HLL Upgrade Kit for adding Horizontal Lifelines to Two Existing SSRA1 Anchors

This Panel Compatibility Chart is provided only as a reference for what the SSRA1 will physically mount to. It does not determine the structural integrity of any roof system or seam. It is the Qualified person's responsibility to verify structural suitability in the event of a fall. The SSRA1 fits over 95% of standing seam panels. It is approved only for 22- and 24-gauge steel and is not compatible with aluminum, zinc, copper, or other soft metals. Do not install on curved, tapered, or batten-seam profiles.

Nailstrip-style panels are approximately 50% compatible. Some seams are too wide at the base, which can allow anchor movement during installation. Treat compatibility lists as guidelines, not guarantees.

It is solely the installer's or specifier's responsibility to confirm SSRA1 suitability for the specific panel and application The employer and the designated Competent Person are solely responsible for evaluating, determining, and documenting the structural suitability of the supporting structure, including its ability to withstand all loads that may occur during a fall or related event. The manufacturer does not review, verify, or warrant the structural capacity of any building, roof system, or attachment surface and assumes no responsibility for structural assessment, adequacy, or performance under fall-arrest or fall-restraint conditions.

Perform a test fit with an RCT seam clamp or SSRA1 anchor well before installation to confirm proper engagement with your exact panel profile.

• Cupped-tip: 22-ga steel—torque to 90 in-lbs
• Nylon-tip: 22/24-ga steel—torque to 180–200 in-lbs

Minor seam dimpling and paint abrasion may occur. Scratches can be touched up with a matching paint pen.